Snowmobile Fanatics banner

1 - 4 of 4 Posts

·
Registered
Joined
·
1,102 Posts
Discussion Starter · #1 ·
what else do i need to do to remove my oiler and run premix. like the lines into the reeds. i have a 1996 ultra sks. what mix ratio should i run also? thanks.
 

·
Registered
Joined
·
8,842 Posts
get a pump delete kit from hiperf.com it will replace your old oil pump and gear drive.
remove oil lines and put silicone on some small bolts and screw them into the carb boots.
mix at what the oil says to go with.
 

·
Registered
Joined
·
1,102 Posts
Discussion Starter · #3 ·
do i really need to put that pump drive gear thing in there. it is really that important? cant i just put a block off plate on it?
 

·
Registered
Joined
·
8,842 Posts
you dont have to put the plug in there. what the plug does is keep the case volume the same, with it out that cylinder will actually have more case volume then the other cylinders. will you notice it on the trail? probably not. you might notice that the plug runs a tiny bit darker than it did before?
 
1 - 4 of 4 Posts
Top