Snowmobile Fanatics banner
1 - 3 of 3 Posts

·
Registered
Joined
·
107 Posts
Discussion Starter · #1 ·
Ok--I have replaced the voltage regulator 2 times and every light on it 2 times. It will idle and go up to about 2000 Rpm's with all the lights on. After I hit about 2000 rpm the headlight blows then after a few minutes the dash lights then the tail light.
Is it possible the 2 voltage regulators were bad (they were used) or is there something else I should be looking at? is there a way to test the volt. reg.?
Also when the lights are working they seem really bright--brighter than normal--the dash lights almost blind you.
I have a new reg. on the way but don't want to risk burning it up if there is another problem that needs to be addressed.
 

·
Registered
Joined
·
2,505 Posts
if the resistance of the regulators is higher than 100 ohms, they're no good.
 

·
Registered
Joined
·
107 Posts
Discussion Starter · #3 ·
I don't get a reading from any of the volt. reg.'s on any setting of the ohm meter. I'll wait for the new one to get here and see what happens.
 
1 - 3 of 3 Posts
Top