Snowmobile Fanatics banner
1 - 4 of 4 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Just rebuilt motor on a 800 assault . Put about 200 miles on and 2 days later opened the coolant fill to check and there was pressure. It blew coolant out. Any suggestions on why?
 

·
Registered
Joined
·
2,729 Posts
Did you burp the coolant properly and get all the air out? Is there a bleeder screw on the head or close to it? Does that bleed steady coolant if you open it? Did you use quality gaskets?

Sent from my SM-G996U using Tapatalk
 

·
Registered
Joined
·
2 Posts
Discussion Starter · #3 ·
Did you burp the coolant properly and get all the air out? Is there a bleeder screw on the head or close to it? Does that bleed steady coolant if you open it? Did you use quality gaskets?

Sent from my SM-G996U using Tapatalk
i did bleed it correct , im thinking maybe a head gasket?
 

·
Registered
Joined
·
2,729 Posts
Sounds like it could be. It doesn't take much to pinch an o-ring but I would think that may rear it's ugly head in the way of leakage.

Sent from my SM-G996U using Tapatalk
 
1 - 4 of 4 Posts
Top