Snowmobile Fanatics banner
1 - 11 of 11 Posts

·
Registered
Joined
·
1,969 Posts
i just use a long bolt through a piece of wood. put the wood on that back side, slide the bolt through it and the clutch, then a big washer and a nut. take out the 6 cover bolts and then back the nut off the bolt.
 

·
Registered
Joined
·
3,236 Posts
You need a tool for that? I just did it last week with my bare hands.
 

·
Registered
Joined
·
2,419 Posts
Im sure you did a search, but...did you?
 

·
Registered
Joined
·
539 Posts
plate steel, long bolt, nut and washers.
 

·
Registered
Joined
·
2,419 Posts
Originally posted by BarkMulcher
[br]?
Sorry that came off arrogant but do you know what section it was in because Im sure it would have been easier to find by switching out some keywords. But Im sure you did that anyways I was just double checking.
 

·
Registered
Joined
·
1,230 Posts
I made one last year. I got a square plate of steel and then cut out a round one with the plasma cutter.

I drilled a hole in the middle of the square and round plate. Then i welded a 1/2 inch diameter threaded rod into the hole of the square plate. then all you need is a washer and nut that fits the threaded rod and there you have a home made primary tool. i dont have any pics of it
 
1 - 11 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top