Snowmobile Fanatics banner

1 - 1 of 1 Posts

6,044 Posts
Discussion Starter #1
I've been reading up quite a bit and see where most folks putting the Ultra and 800XCR motors in the Edge chassis are using 800 twin motor straps.
The general consensus is that you move one strap to where there is already a hole in the chassis, use 2 of the motor mount holes in the straps, and drill the 2 other holes.

Anyone have pictures or anything of the process?
I could use some more detailed instructions as well from folks who have done it.
1 - 1 of 1 Posts