Snowmobile Fanatics banner

Questions about clutch set-up on my SPX

363 Views 0 Replies 1 Participant Last post by  97SPX680
I took my clutch down to the polaris Dealer in Eau Claire. A mechanic there looked at it and told me what i needed to fix/ replace and what to leave alone.

The following parts were in my clutches when I bought it;
Primary Spring: Square tool White
Weights: 10-54
Seconday Spring: Gold
Helix: "36"

The helix was bad so I replaced it with a used "34" one in good condition I got from the polaris dealer. It is the "Correct" helix according to said dealer.

Does anyone have any recomendations for what I should do? The Weights that are supposed to be in there should be 10-58's.

Has anyone done a clutch set-up for low altitude aggressive trail riding on one of these? If so what were the specs on what you did or installed...
1 - 1 of 1 Posts
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.