Snowmobile Fanatics banner

1 - 5 of 5 Posts

·
Registered
Joined
·
50 Posts
Discussion Starter #1
anyone ever cut down a windshield??? if so what did u use to cut the plastic??? any advice? gotta cut this one on my 99 xc.....if that dont work ill put my red low one back on but i want to keep the black one...thx
 

·
Registered
Joined
·
3,888 Posts
Tin snips work good, kinda crude but it gets the job done. I believe others have used jigsaws or die grinders.
 

·
Registered
Joined
·
511 Posts
I have used a Dremil cutting tool with a cutting disc, worked very well, just make sure you tape off where you want to cut with masking tape so you have a guide edge, also clean the cutting disc every once in a while. hope this helps.
 

·
Registered
Joined
·
548 Posts
one of my friends cut down his windshield it will probably look rough around the edges no matter waht but he just got some windshield trim from sportech and it looked like a normal windshield
 

·
Registered
Joined
·
1,749 Posts
I cut mine with a fine blade sawzall. Like backwoodsrider says, use tape to make a line. I re-used the trim I pulled off before hand and it looked factory when all was done.
 
1 - 5 of 5 Posts
Top