Snowmobile Fanatics banner

1 - 4 of 4 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
I was just wondering if anyone had any knowledge on rejetting
and clutching. I am planning a trip to Grand Lake Colorado and need to do a few things to my sled before going. Will be riding in elevations from 8600 to 12000 feet. I have a 03 rev sport and need to rejet and clutch. What jets and needles and clutching do i need to do. Will be riding in temps from 1deg to 20 degrees. I have talked to some parts techs and they just didnt seem real helpful. any information would be great. Thanks
 

·
Registered
Joined
·
8 Posts
Call Xtreme Performance Center 303-654-0867 for rejetting & clutching. They are high elevation specialist here in Colorado. If you are just trail rideing ,any trac will do for that but if you plan on high marking then you would want a long trac with at least 2in paddle. Depending on how long you will be in colorado, it might be cheaper to rent a longtrac sled.
I live 1.5 hour from Grand Lake and there is alot of groomed trails to ride and a lot of sled rental there and Lake Granby.
 

·
Registered
Joined
·
2,419 Posts
jets=270-280
pins=417-004-309 (hollows)
needles=position 2
clickers=5

Those are the 600 specs. If you need the 800s I can find them or give you the site

That should be it I belive. Have a good trip and be safe.
 
1 - 4 of 4 Posts
Top