[Mezk]

I've searched and can't really find a definate answer yes or no...Will 1.25 Ripsaw fit on CK3 chassis(sc-10 susp) without modification? If not how difficult would it be to make it fit?

Money isn't an issue and I'd prefer to get ripsaw if possible

Thanks in advance

 

[Triple650Indy]

Boy I fit a 1" track in a 97' Formula 583 pretty easily. I'm not sure, for sure, but if you did have to modify, all you would have to do is go to smaller drivers on the drive shaft. This is because most of the clearance issues come from that area up there, but you don't have to worry about a heat exchanger up there like the polaris triples and what not.

If you need a ripsaw I have one...

http://www.snowmobilefanatics.com/forum/topic.asp?TOPIC_ID=56644

Make an offer.

 

[SkiDoo55X]

It will fit with no problem. Once you get to 1-1/2 then it starts to get a little tight, but the rip saw is only an 1-1/4 lug, so no issues.

 

[Quinlan]

^ Yep, what he said. I have a 1.2" in my '96 F3, and that has the older suspension setup. It should fit no problem in your newer chassis.