Snowmobile Fanatics banner

1 - 2 of 2 Posts

·
Registered
Joined
·
21 Posts
Discussion Starter #1
Season is once again creeping up on us, and we are offering on a nice complete set of steel dimple dies. All dies are turned from high strength steel for long lasting durability. Set includes four dies with hardware taper bolt and nut. Size range from 1/4- 5/16- 3/8 and 1/2 that means for the 1/4 die you drill a 1/4 hole and so fourth. Dies are very simple to use just drill for the size bolt ,insert the taper bolt and draw the two together. Basic hand tools is all you need and takes about 30 seconds to make a dimple. Will work on both steel and aluminum. Picture taken was used with 1/8 aluminum and will work fine with the 1/2 and 3/8 die,can be done with the 1/4 and 5/16 but would not recommend for long life,designed more for sheet metal and auto body panels.Great for adding traction to floor pans,running boards or giving that custom look to that home built project, actually gives rigidity to the panel after dimple is made.Here is a pictures of a Polaris snowmobile running board and other projects we did. Each die stretches the hole 1/16" and has a dimple height of 1/8" Contact me at [email protected]

$99.00 plus 5.95 shipping.
 

Attachments

1 - 2 of 2 Posts
Top