Snowmobile Fanatics banner
1 - 3 of 3 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
does anyone know if a replacement bushing for the inside sheave is available? the only bushing polaris lists is the large one where the helix goes not the smaller one that rides on the shaft. is a little play acceptable or am i looking at a whole new scondary assembly? thanks
 

·
Registered
Joined
·
129 Posts
yu should be able to get those shims.....are yu talking about play between the clutch and end of the shaft or play in the shaft itself? there should be a little play between the clutch and the end of the shaft...there ia a spec for it...if its too much yu simply add shims
 

·
Registered
Joined
·
1,172 Posts
Yes the small bushings are available. a small amount of play is acceptable. Remove the sring and helix, assemble the two halves together and try to slide them on the shaft putting more force one one side. If it binds replace the bushing if it slides regardless of your pushing on one side more then the bushing is OK
 
1 - 3 of 3 Posts
Top