Snowmobile Fanatics banner
1 - 3 of 3 Posts

·
Registered
Joined
·
156 Posts
Discussion Starter · #1 ·
Just went through my carbs on my sxr and noticed my slides in the idling position were not the same. One is about 1/16th inch higher than the other. I can't find the screw to set it like on the round style carbs I am used to dealing with. Is it a huge deal or is it robbing my performance being off like that? It seems to run fine.

Thanks for any help [thumb]
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top