Snowmobile Fanatics banner
1 - 2 of 2 Posts

·
Registered
Joined
·
30 Posts
Discussion Starter · #1 ·
I have a question about 440 sno pro 02 kill switch. I was riding the other day and i went to go shut it off and i noticed it was loose so i pulled on it and the whole switch came off and a little bit of the actual switch is stuck on the bottom so therefore my sled thinks that the buttom is pressed down and it wont start. i was wondering if there is wire that i could snip or something to disconnect the switch and just use my laniard to shut it off. i need some help on this one. thanks
 

·
Registered
Joined
·
482 Posts
There is probably a connector under the handle bar pad(if you have one) but on the handlebars theres a connector, un plug it and the kill switch is disabled.

these sleds use a normally open ignition, so when you hit the kill switch you actually ground the ingition signal. just unplug the connector and use the key. the connector probably has 3 wires on it, just tape over the ends.
 
1 - 2 of 2 Posts
Top