Snowmobile Fanatics banner

1 - 4 of 4 Posts

·
Registered
Joined
·
863 Posts
Discussion Starter · #1 ·
hey guys, i just picked up a new track. its a 1.5 camoplast thinking it would clear my heat exchanger but it just BARELY touches it. i have been looking at my options and wondering what i should do to get it to have enough clearence.


i was wondering if i could do this:
dropping the rear bolt holding my skid in to the lowest setting. (see below)

20101025153417521_23909.jpg

then this is the part i am wondering.
the track is hitting at the tallest point of the heat exchanger, which is at my middle bolt of the tunnel (not apart of the skid) just the set of wheels the track is going over. (which is where it is rubbing, see below)


20101025153419412_23909.jpg

so i am wondering if i could just drop the skid down to the lowest setting at the back and dropp the middle wheels down the same amount?
will this work?
any opinions would be great. sorry if its a bit confusing, i tried my best [thumb]


20101025154248615_23909.jpg

phone pics so they may not be the best quality
 

Attachments

·
Registered
Joined
·
863 Posts
Discussion Starter · #3 ·
no it clears at the front.
 
1 - 4 of 4 Posts
Top