Snowmobile Fanatics banner

1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
I have the team tied secondary, instructions are not clear at all. It says to instal spacers but not when to where to or how many spacers. When I put the clutch on with stock spacers in behind it the clutch sits too far out on the spindle, so that when I use stock spacers an washer on the retaining bolt it has nothing to push against an when you torque it, it just caves in the washer. As well th spacers provided would not fit on the retaining bolt side, any help would be appreciated. Attached are some pictures that will help describe my situation. Clutch is going on an 03 Polaris Edge 700 XC SP c2.jpg c1.jpg c3.jpg c4.jpg
 
1 - 2 of 2 Posts
Top