Snowmobile Fanatics banner

1 - 2 of 2 Posts

·
Registered
Joined
·
422 Posts
Discussion Starter · #1 ·
I have my carb apart but I cant figure out how to take the throttle assembly off of the spring... Is it possible to leave the throttle valve and spring and such all together and clean it how it is??

Also, I picked up a can of carquest carb cleaner... Has anybody used this? good or bad results?

-Rob
 

·
Registered
Joined
·
172 Posts
I just leave the cable connected to the slide, unless I'm changing the position of the clips on the slide. It's easy enough to put back together, sometimes the washer at the bottom of your spring will fight you when you're putting her back together again, but take your time and it goes.
To take the throttle cable off the slide, compress the spring and allow the washer to fall out of the groove it sits in, and you'll be able to see how the end of the cable needs to slide over a bit to come out.
I think carb cleaner is carb cleaner... I've never heard of any that's bad.
 
1 - 2 of 2 Posts
Top