Snowmobile Fanatics banner
1 - 6 of 6 Posts

·
Registered
Joined
·
2,477 Posts
Discussion Starter · #1 ·
Wanting to know the torque for the studs that hold the jugs/head. torque for the crankcase side not head side. also for the crank case bolts.

Thanks, Brant
 

·
Registered
Joined
·
1,056 Posts
Cylinder head: 18 - 22 ft./lbs. Note: torque head bolts before torquing cylinder base nuts, and apply Loctite 242. This from the service manual

Cylinder base nuts: 30 - 34 ft./lbs.

Crankcase 8mm: 20 - 24 ft./lbs.

Crankcase 10mm: 26 - 30 ft./lbs.

All 6mm crankcase bolts 108 in./lbs.

Anything else?

This is for the SN70LCDCSP-02 motor.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top