Snowmobile Fanatics banner

1 - 2 of 2 Posts

·
Registered
Joined
·
702 Posts
Discussion Starter #1
I got an 01 MXZ 8 (the ZX chassis). For christmas I got a 1.25 Ripsaw, I wont need tunnel protectors will I?
 

·
Registered
Joined
·
4,327 Posts
Not unless you stud it! When you do they are east to put in. Just remove the old ones and slide in the new ones, If i remember right you just have to bend out the rear heat exchanger a tiny bit to get them out then replace and crimp it back with some pliers.
 
1 - 2 of 2 Posts
Top