Snowmobile Fanatics banner

1 - 3 of 3 Posts

·
Registered
Joined
·
66 Posts
Discussion Starter · #1 ·
Hi all.
Im re-installing the jackshaft on my friend's '98 venture 700
I made the error of not taking note of bearing flange position on the clutch end of the shaft.
Can anyone help out with this one with a picture maybe??
I have one flange on either side of the bulkhead and the bearing in-between. I dont think this is correct because the shaft/bearing can move 1/8" side-to-side inside the the flanges.

Do both flanges mount on the inside of the bulkhead?
Thanks guys, really appreciate any help!
 

·
Registered
Joined
·
17 Posts
THE TWO FLANGES SHOULD BE ON THE MIDDLE SIDE WITH BEARING IN BETWEEN BACK SIDE OF OUTER FLANG SHOULD UP AGAINCE INSIDE OF BULKHEAD ILL TRY TO GET U APIC OR TWO AFTER SUPPER
 
1 - 3 of 3 Posts
Top