Snowmobile Fanatics banner

1 - 5 of 5 Posts

·
Registered
Joined
·
43 Posts
Discussion Starter · #1 ·
Ok time to replace the pto needle and seat on my 85 pol indy 600 and looking thro the dennis kirk catalog and there are several that look like mine any one know what part numbers i need?
 

·
Registered
Joined
·
43 Posts
Discussion Starter · #2 ·
ok finaly got some one there to help me a bit but i think im more confused
he told me i THINK you need a vinton tip with a 2.0 flow rate ? this is all greek to me so any one else this is what i need ?
 

·
Registered
Joined
·
11,943 Posts
It sounds like he is giving you the right information. You need a needle and seat for a 38 mm Mikuni VM carb. I would go with a 1.5 size being you have a fuel pump. The 2.0 has a larger inlet hole but it is harder for the needle to shut off if there is to much fuel pressure. The viton tip means that it is a rubber style tip that is not affected by gasoline.
 

·
Registered
Joined
·
5,686 Posts
If you are going to replace 1,replace them on all 3 carbs.
 
1 - 5 of 5 Posts
Top