Snowmobile Fanatics banner

1 - 3 of 3 Posts

·
Registered
Joined
·
328 Posts
Discussion Starter · #1 ·
Iam putting another coil on my indy 600. It is used but I think it is better then the other one in right now. The only problem is the two wires that come out of the cdi that connect to the coils are missing the coating around the copper wire right where it comes out of the cdi. It has two wires that come out of this point and both are missing the coating. Any suggestions on how to re-coat electrical wiring. Thanks
 

·
Registered
Joined
·
172 Posts
You can also buy some stuff called "Heat Shrink", it'll last longer than tape & it's waterproof. You cut it to length, put it over your wires, and just use a hairdryer if you don't have a heat gun to shrink it down so it form fits onto your wires.
The stuff we use at work is made by Alpha wire company & it comes in a variety of colors.

http://www.alphawire.com/pages/136.cfm
 
1 - 3 of 3 Posts
Top