Snowmobile Fanatics banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Hey guys new to this forum. I have a 2000 XCR 800 ive had a couple years but haven't got to ride much. It has HTG pipes, V2 reeds with new petals and HTG heads. engines stock other than that. Has 440 main jets and the stock needles with clips in the middle. It supposedly is clutched for the pipes but haven't had the clutches apart yet. Think it has an almond spring in the primary. It just doesn't seem as powerful as it should be. Motor is fresh maybe 200 miles.Good compression. 1.25 rip saw and 192 studboy power points. Just looking for somebody here with a good clutch setup in theirs to point me in the right direction on clutching and jetting. I ride high speed trails almost like an XC race :) and drag my friends alot and out on the lakes. Mostly trails and drags though. any help is greatly appreciated.
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top