Snowmobile Fanatics banner

1 - 4 of 4 Posts

·
Registered
Joined
·
81 Posts
Discussion Starter #1
Just finish carb rebuild on 600 triple with 32mm carbs.Problem Im having it idles fine,but when I start to accelerate RPMs start rising and woul'nt come back with throttle release.Cables seem to be free.Pulled carb tops, nothing hanging up.Im sure they'll have to come back off.My question is, any thoughts on what to look for?
Also adjusting cable length has caused a problem at that damn safty switch.Refresher on that adjustment appreciated. ANd yes I did double check oil pump settings! Thanks C/M
 

·
Registered
Joined
·
301 Posts
assuming that you have synched the carbs,
it sounds like it is too lean,
turn the mixture screws in about 1/2 turn.

you want about .010" of throttle lever freeplay.

initial idle speed is set with the throttle cable
disconnected from the throttle lever.
this ensures that the throttle slides are
resting on the idle screed screw.
 

·
Registered
Joined
·
81 Posts
Discussion Starter #4
Thanks for the replies. Tore carbs down again (got a new batch of carb cleaner)put back together.., runs fine! Probably a cling-on stuck in some port.Alot to be said.,(If its not broke dont f### with it!
 
1 - 4 of 4 Posts
Top