Snowmobile Fanatics banner

1 - 4 of 4 Posts

·
Registered
Joined
·
3,675 Posts
Discussion Starter · #1 ·
What's Up Guys,

I have a 95 XLT sp that i just put a 3 inch handlebar riser on. The problem is the throttle cable is about 2 inches on the short side. Easy enough to get a longer throttle cable, however the problem I am running into is getting the plastic cable junction box apart. It's the piece that all the carb and oil pump cables run into and then the single throttle cable comes out of. I would like to just open the box up and put in a longer cable from there versus running all new lines from the carbs and oil pump. Does anyone have any suggestions for popping this plastic box open. Thanks for any suggestions...
 

·
Registered
Joined
·
109 Posts
THey have a part that you can get out of Dennis Kirk that hooks right to the throttle cable to make to longer so you don't have to open that box.
 

·
Registered
Joined
·
3,675 Posts
Discussion Starter · #3 ·
Thanks Joe,

That looks like just the ticket.
 

·
Super Moderator
Joined
·
11,279 Posts
yep thats the best way to go..
 
1 - 4 of 4 Posts
Top