Snowmobile Fanatics banner

1 - 2 of 2 Posts

·
Registered
Joined
·
36 Posts
Discussion Starter #1
I have a 97 vmax 600 XTC (twin) I have a 23 tooth sprocket and I just put in a 21 for more low end power also I want a do clutch work but I never touched one before and I was found one from Moutain performance, how intense is this project before the snow flys. Also I have no clue on how to the weights so if you can help. I have a little right now in the U.P of Michigan.

Justin Jarmus
 

·
Registered
Joined
·
2,584 Posts
Yamaha clutch work is easy with the right tools. Takes some force, usually a vice, and time. Its not a long rpoject no more than a couple hours but i have never done weights so can;t help there.
 
1 - 2 of 2 Posts
Top