Snowmobile Fanatics banner

1 - 4 of 4 Posts

·
Registered
Joined
·
324 Posts
Discussion Starter · #1 ·
When I start up my sled it idles fine. If you take her for a ride on the trails and stop it will idle down to about 500-200 RPM and then stall. Plugs have been fine. Carbs are clean. What should the idle screws be set at?[8D]
 

·
Registered
Joined
·
324 Posts
Discussion Starter · #2 ·
One more thing, when you hammer it she bogs, not real bad but you can feel it when it does finally kick in. any ideas?
 

·
Registered
Joined
·
27 Posts
Ok just an Idea but if your sled is equiped with a fuel pump which is more than likely it could be dirty. It does not take much to make them act up. If you are sure the carbs are clean thats the next thing I would check.
Again just an Idea. :)
 

·
Registered
Joined
·
608 Posts
Sleds idle higher when they are cold. Your best route is to set the idle when it is all warmed up. Depending on your sled theidle should be at 1400-1800 rpm. You can even go as high as 2000 if you need to.
 
1 - 4 of 4 Posts
Top