I read all about the ett suspension skid swap for the older sleds. I have a 1996 ZRT 600 and bought a tsl skid out of a 2000 zl 500. I followed the instructions I found to a T to swap out these skids. Apparently after drilling everything out and trying to fit the suspension in. the ZL and ZR have diiferent measurements I driled measurments for a zr skid. So i would REALLY appreciate some help or measuments if someone else has swapped a ZL tsl suspension into an older sled. Thanks alot!!
ZL suspension in a ZRT
1 - 5 of 5 Posts
Joined
·
1,716 Posts
The ZR skid front arm is 16 1/4" long.
The ZL skid front arm is 14 3/4" long.
It should put you a lot closer to using your original front mount plate.
Read this thread.
http://www.arcticchat.com/forums/index.php?showtopic=32042
I'm sure the measurement's you need are in there somewhere.
I can't do it tonight, but if you still need the measurement's, I can get them from My 98 EXT tomorrow.
Rick
The ZL skid front arm is 14 3/4" long.
It should put you a lot closer to using your original front mount plate.
Read this thread.
http://www.arcticchat.com/forums/index.php?showtopic=32042
I'm sure the measurement's you need are in there somewhere.
I can't do it tonight, but if you still need the measurement's, I can get them from My 98 EXT tomorrow.
Rick
1 - 5 of 5 Posts
Join the discussion
Join now to ask and comment!