This winter I had replaced all of the engine and water pump seals. Went and got it fired up and it was burning coolant. Pulled off the cylinder head and found I had a pinched cylinder head seal. Replaced them all but I didn't have time to continue working on it so it sat for about 2 weeks. Came back to it today, pulled it over and now its sucking tons of coolant and blowing it right out. So i pulled the cylinder head again and all the o rings were good. Then i took it outside and pulled it over probably 100 times. Every time it shoots out a ton of fluid. I figured all the coolant would have got out of the bottom end but now it must be running right in from the water pump.
What you guys think I might have done wrong?
I know I put all the seals in. I replaced literly every seal including the mechanical water pump seal.
And help would be appreciated.
Thanks
What you guys think I might have done wrong?
I know I put all the seals in. I replaced literly every seal including the mechanical water pump seal.
And help would be appreciated.
Thanks