Snowmobile Fanatics banner

1 - 3 of 3 Posts

·
Registered
Joined
·
479 Posts
Discussion Starter · #1 ·
Hey folks,

After much hassle i'm putting my 2000 ZR 440 Sno Pro top end back together. Does anybody have the head as well as the cylinder base specs? (even if its not a 440 give me the specs, I dont think its crucial)

Dealer said check the internet and I can't find anything on the cat site.

Thanks.
 

·
Registered
Joined
·
450 Posts
man if you do enough engines you dont even need the specific specs. people with experience can feel the stretch in the bolt. but anyway heres some basic numbers for ya, torque the base bolts to about 18 ft/lbs. head bolts first go to 12 ft/lbs, and then finish somewhere between 20/24 ft/lbs.
 

·
Registered
Joined
·
450 Posts
man if you do enough engines you dont even need the specific specs. people with experience can feel the stretch in the bolt. but anyway heres some basic numbers for ya, torque the base bolts to about 18 ft/lbs. head bolts first go to 12 ft/lbs, and then finish somewhere between 20/24 ft/lbs.
 
1 - 3 of 3 Posts
Top