Snowmobile Fanatics banner

ZRT 600 Seat removal

5369 Views 7 Replies 7 Participants Last post by  Flange
Greetings all!! New member here! A question for the wrencheads!! A friend of mine has a 96 ZRT on which he is trying to replace the seat. We've both looked through our manuals and can't find anything about how to remove the seat. Does anyone have any experience with one of these? Any help would be greatly appreciated!!
1 - 8 of 8 Posts
I don't know the answer to your question but I just want to welcome you to the forum! I'm hope you have a great time here!

2002 Arctic Cat ZR 800 EFI

founding member of the Arctic Cat Mind Control will believe!!​
See less See more
most of the time, you have to drop the track and suspension and there will be some bolts or screws up under the tunnel

See less See more
My Yamaha has two nuts on studs inside the trunk space that were 'hidden' in the foam. Near the back on each side, you can try there.

My Xlts have two nuts on studs up under the tunnel. Harder to get at, but more obvious.

I wouldn't have thought a need to drop the track to do that, just a small deep socket and ratchet should do once you locate the nutz.

I think.... therefore I sled
Two '94 Indy XLT SKS
See less See more
I think you will find the nuts in the trunk space to take the seat off.
You should have 2 nuts in the trunk and the heads of the bolts in the tunnel.

96zrt has 2 bolts in the trunk remove those and the cowl over the gas tank and slide it out to the rear. the seat and the tank are 1 piece.

Mean Green Racing
Elyria, Ohio
Bingo Spaceman! You'll also have to remove the gas and vent lines. Make sure the tank is empty!
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.