[Sledneck26]

Well. i got some gifts this morning. I got a new bar setup! 4 inch riser bars, grips, and warmers. and some other stuff. Now the question is. how to i hook em up.. I've tried some things, nuthin worked though

the setup

the left warmer wires

the french! diagram[confused]

right warmer wires

stock wires

there are 2 sets of 2 stock wires that came off the old bars. show in the last pic. i am assuming 2 are ground and 2 are power.

now the warmer pads are 2 wire also and there are 2 of them. i tried hooking the pads the the stock 2 wires, didnt work. then switch them around and still didnt work. im confused and have no idea how to do this...

 

[TBWdracula2003]

take a tester , ground it and find the hot wires then hook them up accordingly

 

[Sledneck26]

Ok, i found the english instructions. few questions though. whats a suitable ground location on my sled? and it says hook directly to the yellow wire(+) on the magneto, will this wire be totally visable? and can i cut it or splice it?

 

[polaris91]

are you shure they diddent work when you hooked them to the old ones sid you ride the sled around a bit so they had a chance to warm up it takes a little while did you try tracing down to where the old wires connected

 

[Sledneck26]

i let the sled idle for like 10 mins. and nothing on each attempt. i've seemed have lost my volt meter and power tester. so i have to buy another or borrow one. I just need to find a suitable ground. can you give me some ideas for ground locations. and can i cut my yellow wire that comes from the magneto? what else does it power.